火焰光度檢測器(FPD)是一種高靈敏度高選擇性的測定硫磷化物的氣相色譜檢測器。但是FPD測硫時的選擇性并不好,在測低濃度硫化物時靈敏度也不高,且線性較差。因此,當試樣中含有大量烴類時,必須用色譜柱把烴類與硫化物完全分離,此時的選擇性(S/C)為10~4,否則就會受到烴類的嚴重干擾,甚至信號完全消失。

滕州市浩瀚色譜儀器技術服務有限公司研發出GC790DFPD雙火焰光度檢測器，組分在上下火焰中同時燃燒，當出溶劑峰時，下火焰可能熄滅，上火焰仍然燃燒，待溶劑峰過后，下火焰會自動點燃。DFPD避免了SFPD易淬滅的缺點，還使硫的響應值與硫原子流速平方成正比，而與化合物的分子結構無關，但靈敏度稍低于SFPD。

Flame Photometric Detector (FPD) is a high sensitivity and high selectivity gas chromatographic detector for the determination of sulfur phosphide. However, the selectivity of FPD is not good, the sensitivity is not high when the concentration of sulfide is measured, and the linearity is poor. Therefore, when the sample contains a large number of hydrocarbons, you must use the column to completely separate the hydrocarbons and sulfides, the selectivity (S / C) of 10 to 4, otherwise it will be severely interfered by hydrocarbons, Even the signal completely disappeared.

        Tengzhou City, the vast spectrum of instruments Technical Services Limited developed GC790DFPD dual flame photometric detector, the components in the upper and lower flame at the same time burning, when the solvent peak, the flame may be extinguished, the flame is still burning until the solvent peak after the flame Will automatically ignite. DFPD avoids the disadvantage of SFPD being easily quenched, and the sulfur response is proportional to the square of the flow rate of the sulfur atom, independent of the molecular structure of the compound, but somewhat less sensitive than the SFPD.